Building V3 will be a similar process to V2. This house will eventually be moved from our building yard via trailer to a new, semi-permanent location. Like V2, this house is being built on temporary supports which we will remove once a trailer is ready and once the house is prepped for moving.
We started with the floor, which is 2X8s on 16” centres insulated with about 5 inches of rigid foam that we got from a roofing company from a renovation they did. Next, we stood the tall front wall (with the help of a few local strong-men – thanks guys!), the shorter back wall and then placed the massive header/beam that runs the length of each wall and ends with the “wings” that Nelson Tiny House enthusiasts like so much.
The roof structure for this house will be different than anything we've done. We are building an insulated ceiling made of 2X4s that will be clad on the inside with local hemlock 1X material. That ceiling structure will then be temporarily tarped, shielding the whole house from snow and rain. We will build the 2X8 rafter system on the ground, and in modular parts. This will allow us to transport the house without the big shed roof that would greatly increase the house's length and width and pose all sorts of logistical problems. Once the house is in place at its future home, we will put the rafter system up in a short time and the whole thing will be warm and weather-proof. We'll post pictures of all of that once we've built it.
Thanks for reading. Here are some current photos.